OpenShack Box Hardware Settings

Connect

Linux: no port in the list, or it won't open?
Ubuntu Chromium (snap): sudo snap connect chromium:raw-usb and sudo snap connect chromium:serial-port, then restart the browser.
Chrome/Edge (.deb/.rpm): sudo usermod -aG dialout $USER, then log out and back in.

Device

Firmware—

MAC—

Transport—

Firmware

Connect to check for firmware updates.

Networks

WiFi radio ON

SSID

RSSI

Security

WiFi: —

Credentials

SSID

Password

Use DHCP

Netmask

Gateway

DNS

Volume

Speaker (0–100)

Headphone (0–100)

Output route

Force PA OFF

Line-in mix

Mix-through ON Digital mix mode (off = analog)

Mix volume % (0–100)

Bandpass filter (digital only)

Low cut Hz (50–5000)

High cut Hz (500–20000)

Sidetone

Sidetone ON

Frequency Hz (550–750)

Gain % (5–200)

Mix HP % (50–400)

Mix SPK % (50–400)

Ramp ms (2–15)

Bluetooth LE

BLE ON

Bluetooth LE and WiFi cannot run at the same time: switching BLE on turns the Box's WiFi off; switching it off restarts the Box so WiFi comes back.

BLE: —

Bluetooth audio (A2DP sink)

Bluetooth audio ON

Bluetooth Classic audio and WiFi cannot run at the same time: switching audio on turns the Box's WiFi off; switching it off restarts the Box so WiFi comes back.

BT gain % (0–100)

BT: —

Keyer

Paddle type

Orientation

WPM (5–100)

Ultimatic priority

Switchpoint dot % (0–100)

Switchpoint dash % (0–100)

Weight (10–90)

Ratio (250–350)

Latency % (0–100)

Compensation ms (0–250)

Farnsworth

Farnsworth WPM (5–100, must be < WPM)

Paddle watchdog

Watchdog timeout s (5–120)

Pause Memory (Iambic B — enable at switchpoint 0%) Autospace CW output ACTIVE-HIGH (off = ACTIVE-LOW) PTT output ACTIVE-HIGH (off = ACTIVE-LOW)

Announce

Text (Morse sidetone, no key-out)

Outputs

CW key output (KEYOUT) PTT enabled Footswitch input

PTT timing

Delay / tail ms (0–1000)

Lead-in ms (0–1000)

1st element extension ms (0–250)

Manual transmit

XMIT auto-RX after s (1–30)

Tune

Duration s (1–30)

Macro 1

Macro 2

Configurable buttons

KEY3

KEY4

SPKONOFF toggles the runtime speaker mute. SPKVOL cycles the speaker sidetone mix OFF / 50 / 100 / 150 / 200 / 250 / 300 / 350 / 400 %. SIDETONEVOL cycles the master sidetone gain OFF / 20 / 40 / 60 / 80 / 100 % and remembers the OFF state. PTT toggles the transmitter (asserts / releases PTT).

Configuration

Role

Target IP / DNS name

Target port (blank = 7373)

Shared secret (write-only — never echoed back)

Jitter profile (host-owned)

Min jitter ms (150–1000)

Connection mode

Direct Relay

Enable Box-2-Box UDP - default: on

UDP repeat (default: 70ms)

IPv6 (dual-stack) — off = pure IPv4

IP preference (hostname targets; IP literals pin their own family)

Status

Live status