OpenShackby DL2CCShop

OpenShack Remote · Windows

Try out OpenShack Remote

Connect to a remote station running a contest simulation. Tune the band in Remote Control, watch the waterfall and hear your own microphone on SSB. Try the Keyer for voice or CW.

You need an internet connection and headphones or speakers. You can try the demo without a radio, OpenShack Box or Remote license.

All signals stay in the simulation. Nothing is transmitted on a real radio.

Connect to a demo station

  1. Install OpenShack for Windows. On the welcome screen, under TRY A REMOTE STATION, click OPEN REMOTE STATION. If OpenShack is already running, open Remote Connect as a client.
  2. In Welcome to Remote World!, enter your callsign. Under Receive audio, select your headphones or speakers and click TEST. For the SSB test, select your own mic under Microphone. Click NEXT.
  3. Click CONNECT. OpenShack finds a free demo station and opens Remote Control, the waterfall and the DX cluster. CQ WW is already running. To change contests, select one and click USE.

Already set up? Open Stations in Remote Connect and connect to a demo station with a green light, such as DXARENA1. If all are busy, click TRY AGAIN later.

Tune the band and watch the waterfall

Turn the VFO in Remote Control. Watch the tuned frequency move across the Waterfall and listen as you pass signals. Double-click a DX spot, or click its QSY column, to tune straight to that station.

Test your microphone on SSB

Select USB or LSB in Remote Control. In that window, hold the space bar and speak into your microphone. Release it to hear your echo. The demo station plays back up to 30 seconds of your transmission.

Send voice or CW with the Keyer

In Remote Connect, open Keyer.

  • Voice: Stay on SSB and select the Voice tab. Turn on Record Mode, press an empty F-key, speak, then press the same key to stop. Record Mode turns off automatically. Press that key again to send the recording. Listen for the echo.
  • CW: Select CW in Remote Control and open the Keyer’s CW tab. Type your callsign under Send and press Enter to answer a CQ.

Want to go deeper?

Use separate virtual COM pairs for CAT and CW. In your logbook software, select Kenwood TS-2000 on COM22 for CAT and WinKey on COM24 for CW. OpenShack uses the partner ports, normally COM21 and COM23. If setup assigned different numbers, use its port list. See the TS-2000 and WinKey settings.

Tune the VFO and watch the frequency change in your logbook software. Then send your callsign from a CW memory.

Back to OpenShack Remote